TEMPORARY DEAD END ARM
The Temporary Dead End Arm enables a line crew to spread conductors off an existing dead end arm to gain
working bbbbbance to replace and terminate new conductors.
FEATURES AND BENEFITS:
•  Arms are constructed with 3” diameter fiberglass and a foam core to meet most load requirements for tempo -
rary dead ends. 
•  Load limit - 500 lbs. per bbbbbbbb or 1,000 lbs. total load limit.
•  Arms have two holes with 18” spacing to accommodate 5/8” diameter hardware bolts for dead ends.  Two alu-
minum sleeves are installed to prevent wear on the fiberglass arm.
•  Steel mounting brackets have multiple holes for adjustment to fit various arm sizes.  Note:  adjustment range is
described for all catalog numbers shown below.
•  Arms can be installed on either the top or bottom of existing cross arms.
•  Two styles are available.  Butt swivel eye to dead end a single phase tap line or a 3 way aluminum alloy equip-
ment mounting bracket for mounting a cutout, lighting arrester and a dead end tap line.
•  When utilizing the butt swivel or the equipment mounting bracket for temporary hanging of a tap line; only
slack spans are recommended with loads not to exceed 150 lbs., providing that the Dead End Arm is being held
captive on the crossarm.